RIPng
*****

*ripngd* supports the RIPng protocol as described in **RFC 2080**.
It's an IPv6 reincarnation of the RIP protocol.


Invoking ripngd
===============

There are no *ripngd* specific invocation options. Common options can
be specified (Common Invocation Options).


ripngd Configuration
====================

Currently ripngd supports the following commands:

router ripng

   Enable RIPng.

flush_timer TIME

   Set flush timer.

network NETWORK

   Set RIPng enabled interface by NETWORK.

network IFNAME

   Set RIPng enabled interface by IFNAME.

route NETWORK

   Set RIPng static routing announcement of NETWORK.

router zebra

   This command is the default and does not appear in the
   configuration. With this statement, RIPng routes go to the *zebra*
   daemon.


ripngd Terminal Mode Commands
=============================

show ip ripng

show debugging ripng

debug ripng events

debug ripng packet

debug ripng zebra


ripngd Filtering Commands
=========================

distribute-list ACCESS_LIST (in|out) IFNAME

   You can apply an access-list to the interface using the
   *distribute-list* command. ACCESS_LIST is an access-list name.
   *direct* is "in" or "out". If *direct* is "in", the access-list is
   applied only to incoming packets.:

      distribute-list local-only out sit1